RX 350 FWD V6-3.5L (2GR-FE) (2010)
Fluid - A/T: Service and Repair
U660F Automatic Transaxle
Up to 08/2009
U660F AUTOMATIC TRANSMISSION / TRANSAXLE: AUTOMATIC TRANSAXLE FLUID: ADJUSTMENT
1. PRECAUTION (w/ Air Suspension)
NOTICE:
Be sure to read Precaution thoroughly before servicing See: Steering and Suspension/Suspension/Service Precautions/Air
Suspension System.
2. PRECAUTIONS AND WORK DESCRIPTION
(a) The U660F automatic transaxle does not have an oil filler tube and oil level gauge. When adding fluid, add fluid through the refill hole on the
transaxle case. The fluid level can be adjusted by draining excess fluid (allowing excess fluid to overflow) through the No. 1 transmission oil
filler tube of the oil pan.
HINT
"Overflow" indicates the condition under which fluid comes out of the overflow plug hole.
(b) Before adjusting the fluid level, add the specified amount of fluid when the engine is cold and warm up the engine to circulate the fluid in the
transaxle. Ensure that the fluid temperature is as specified and the engine is idling.
(c) The U660F automatic transaxle requires Toyota Genuine ATF WS.
(d) The adjustment should be performed according to the procedures and notes.
3. WORK FLOW
(a) The adjustment should be performed according to the procedures referenced in the work flow below.