RX 350 FWD V6-3.5L (2GR-FE) (2010)
NOTICE:
Do not pause for more than 1.5 seconds.
HINT
Performing this operation will cause the vehicle to enter the fluid temperature detection mode.
(6) Check that the D shift indicator comes on for 2 seconds.
HINT
*
When the fluid temperature detection mode is activated, the D shift indicator on the combination meter comes on for 2 seconds.
*
If the D shift indicator does not come on for 2 seconds, return to the step where terminal TC is first connected and perform the
procedure again.
(7) Move the shift lever from N to P.
(8) Release the brake pedal.
(9) Remove SST from terminals 13 (TC) and 4 (CG).
Text in Illustration
SST : 09843-18040
NOTICE:
Be sure that terminals TC and CG are not connected. If the terminals are connected, the fluid level cannot be precisely adjusted due
to fluctuations in engine speed.
HINT
*
Disconnecting terminals TC and CG activates the engine idle control mode.
*
In the engine idle speed control mode, engine idle speed control starts when the fluid temperature becomes 35°C (95°F) or more
and the engine speed is maintained at approximately 800 rpm.
*
Even after terminals TC and CG are disconnected, the fluid temperature detection mode is active until the engine switch is turned
off.
(10)Allow the engine to idle until the D shift indicator comes on again.