RX 350 FWD V6-3.5L (2GR-FE) (2010)
(a) Install the air cleaner bracket with the 3 bolts.
Bolt A - Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)
Bolt B - Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)
3. INSTALL BATTERY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation
4. INSTALL INLET NO. 1 AIR CLEANER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
5. INSTALL INLET NO. 2 AIR CLEANER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
7. INSTALL COOL AIR INTAKE DUCT SEAL See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
8. INSTALL ENGINE ROOM SIDE COVER LH See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
9. INSTALL ENGINE ROOM SIDE COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal and
Replacement/Installation
10. CHECK AUTOMATIC TRANSAXLE SYSTEM
NOTICE:
If automatic transmission parts have been replaced, refer to Parts Replacement Compensation Table to determine if any additional
operations are necessary See: Transmission Control Systems/Service Precautions/U660E Automatic Transaxle System.