RX 350 FWD V6-3.5L (2GR-FE) (2010)
(b) Start the engine and make sure that the vehicle moves forward when moving the shift lever from N to D and moves rearward when moving the
shift lever to R.
If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly
installation condition.
2. ADJUST SHIFT LEVER POSITION
(a) Apply the parking brake and move the shift lever to N.
(b) Remove the console box See: Shifter A/T/Service and Repair/Removal and Replacement/U660F Automatic Transaxle/Removal.
(c) Disconnect the shift lock control ECU connector and transmission control switch wire connector.
(d) Disconnect the 3 clamps.
(e) Remove the 4 nuts and shift lever assembly.
(f) Disconnect the end of the transmission control cable assembly from the shift lever assembly.
(g) Turn the lock nut counterclockwise. While holding the lock nut, disconnect the transmission control cable from the shift lever retainer.
(h) Slide the slider of the transmission control cable in the direction indicated by the arrow and pull the lock piece outward.
Text in Illustration