RX 350 FWD V6-3.5L (2GR-FE) (2010)
2. REMOVE BATTERY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Removal
3. REMOVE V-BANK COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Removal
4. REMOVE INLET NO. 2 AIR CLEANER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
5. REMOVE INLET NO. 1 AIR CLEANER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
6. REMOVE AIR CLEANER ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Removal
7. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Move the shift lever to N.
(b) Disconnect the wire harness clamp.
(c) Remove the nut from the control shaft lever.
(d) Using a screwdriver, disengage the 4 claws, disconnect the control cable with clip from the control cable bracket.
(e) Remove the clip.
(f) Turn back the carpet.
(g) Remove the 3 bolts and pull out the transmission control cable assembly from the body.
Up to 08/2009
U660F AUTOMATIC TRANSMISSION / TRANSAXLE: TRANSMISSION CONTROL CABLE: INSTALLATION
1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
NOTICE: