RX 350 FWD V6-3.5L (2GR-FE) (2010)
NOTICE:
*
Make sure that the claws A on the clip are securely fit into the bracket holes.
*
Make sure that the cable is securely installed inside of the claws B of the clip.
(f) Connect the transmission control cable to the control shaft lever with the nut.
Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)
NOTICE:
Before connecting the transmission control cable assembly, check that the park/neutral position switch and the shift lever are in
neutral.
2. INSTALL AIR CLEANER ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Installation
3. INSTALL INLET NO. 1 AIR CLEANER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
4. INSTALL INLET NO. 2 AIR CLEANER See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Installation
5. INSTALL V-BANK COVER SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Engine Assembly/Installation
6. INSTALL BATTERY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine Assembly/Installation
7. INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT ASSEMBLY
HINT
See the steps from "Install Instrument Panel Reinforcement Assembly with Air Conditioning Unit Assembly" through "Inspect SRS
Warning Light" See: Heating and Air Conditioning/Housing Assembly HVAC/Service and Repair/Removal and
Replacement/Installation.
8. INSPECT SHIFT LEVER POSITION See: Adjustments/U660F Automatic Transaxle
9. ADJUST SHIFT LEVER POSITION See: Adjustments/U660F Automatic Transaxle