RX 350 FWD V6-3.5L (2GR-FE) (2010)
Repair/Removal and Replacement/Removal
10. REMOVE NO. 1 SWITCH HOLE BASE See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Removal
12. REMOVE INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
13. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Removal and Replacement/Removal
14. REMOVE CONSOLE BOX See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Removal
15. REMOVE SHIFT LEVER ASSEMBLY
(a) Move the shift lever to N.
(b) Disconnect the shift lock control ECU connector and transmission control switch wire connector.
(c) Disconnect the 3 clamps.
(d) Remove the 4 nuts and shift lever assembly.
(e) Disconnect the end of the transmission control cable assembly from the shift lever assembly.
(f) Turn the lock nut counterclockwise. While holding the lock nut, disconnect the transmission control cable from the shift lever retainer.
From 08/2009
U660F AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: REMOVAL
1. PRECAUTION
NOTICE:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL