RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-1625020.png)
55 mm (2.17 in.)
NOTICE:
*
When installing the transmission valve body assembly, be careful not to allow the transmission revolution sensor and transaxle
case to interfere with each other.
*
Be sure to insert the pin of the manual valve lever into the groove on the end of the manual valve.
*
First, temporarily tighten the bolts marked *1 in the illustration because they are positioning bolts.
3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY
(a) Coat a new O-ring with ATF and install it to the oil strainer.
Text in Illustration
NOTICE:
Ensure that the O-ring is not twisted or pinched.
(b) Install the oil strainer to the valve body with the 2 bolts.
Torque : 11 Nm (112 kgf-cm, 8 ft-lbf)
4. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY
(a) Install the 2 magnets to the oil pan.
Text in Illustration
(b) Install a new gasket to the oil pan.
(c) Apply adhesive to the 18 bolts.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
