RX 350 FWD V6-3.5L (2GR-FE) (2010)
Standard Resistance:
Text in Illustration
(b) If the value is not as specified, replace the shift solenoid valve.
(c) Connect a positive (+) lead from the battery with a 21 W bulb to terminal 2 and a negative (-) lead to terminal 1 of the solenoid valve
connector, and check the operation of the valve.
NOTICE:
When using battery voltage during the inspection, do not bring the positive (+) and negative (-) tester probes too close to each other as
a short circuit may occur.
OK:
The valve moves and makes an operating sound.
(d) If the operation cannot be done as specified, replace the shift solenoid valve.
3. INSPECT SHIFT SOLENOID VALVE SLU
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance: