RX 350 FWD V6-3.5L (2GR-FE) (2010)
(f) Lower the rear differential carrier assembly with differential support slowly to remove the rear differential carrier assembly with differential
support.
NOTICE:
Do not damage the vacuum hose and electro magnetic control coupling wire harness.
Text in Illustration
17. REMOVE DIFFERENTIAL SUPPORT
(a) Remove the 3 bolts and differential support.
18. REMOVE UPPER REAR DIFFERENTIAL MOUNT STOPPER
(a) Remove the 2 upper rear differential mount stoppers from the No. 1 rear differential support.
19. REMOVE NO. 1 REAR DIFFERENTIAL SUPPORT
(a) Remove the 2 bolts, 2 nuts and No. 1 rear differential support.
HINT
The nuts have tabs to prevent them from rotating.
Up to 08/2009
AXLE AND DIFFERENTIAL: REAR DIFFERENTIAL CARRIER ASSEMBLY: INSTALLATION
NOTICE:
If installing a new rear differential carrier assembly, remove the 2 differential side seal caps before installing the rear drive shaft
assembly.
1. TEMPORARILY TIGHTEN NO. 1 REAR DIFFERENTIAL SUPPORT
(a) Temporarily install the No. 1 rear differential support to the rear differential carrier assembly with 2 new bolts and 2 new nuts.