RX 350 FWD V6-3.5L (2GR-FE) (2010)
Torque : 20 Nm (200 kgf-cm, 14 ft-lbf)
NOTICE:
*
Do not damage the diaphragm oil seal.
*
Do not damage the contact surface of the rear differential carrier assembly and electro magnetic control coupling sub-assembly.
37. INSTALL REAR DIFFERENTIAL CARRIER COVER BREATHER PLUG
(a) Using a socket wrench, service nut and a hammer, install the rear differential carrier cover breather plug to the rear differential carrier.
HINT
*
Use a service nut with an inner diameter of 13 mm (0.512 in.) and a socket wrench appropriate for the service nut.
*
Tap in the rear differential carrier cover breather plug until it sits flush with the rear differential carrier assembly.
38. INSPECT ELECTRO MAGNETIC CONTROL COUPLING SUB-ASSEMBLY
(a) Install a dial indicator and magnetic base so that it is perpendicular to the inner side of the electro magnetic control coupling sub-assembly as
shown in the illustration.
(b) Using SST, rotate the electro magnetic control coupling sub-assembly forward and backward, and measure the vertical runout.
SST : 09564-32011
Maximum runout:
0.06 mm (0.00236 in.)
(c) If the runout is greater than the maximum value, replace the electro magnetic control coupling sub-assembly.
(d) Install a dial indicator and magnetic base perpendicular to the electro magnetic control coupling sub-assembly as shown in the illustration.
(e) Using SST, rotate the electro magnetic control coupling sub-assembly forward and backward, and measure the lateral runout.
SST : 09564-32011
Maximum runout:
0.07 mm (0.00276 in.)
(f) If the runout is greater than the maximum value, replace the electro magnetic control coupling sub-assembly.
39. INSTALL REAR DIFFERENTIAL FILLER PLUG