RX 350 FWD V6-3.5L (2GR-FE) (2010)
Text in Illustration
SST : 09570-48010
(A):
9.8 to 10.8 mm (0.386 to 0.425 in.)
(B):
+/- 3°
NOTICE:
*
Apply grease to the threads of the SST bolts before use.
*
Do not set SST in the wrong direction.
*
Be sure to use SST in the correct combination.
*
Install the rear differential mount cushion within +/- 3° from the center.
*
Temporarily install the rear differential mount cushion to the rear suspension member before installing SST to prevent the rear
differential mount cushion from being tilted.
*
Install the rear differential mount cushion so that the protrusion is positioned as shown in the illustration.
*
Make sure that SST contacts the entire rear differential mount cushion seating surface.
*
Do not slant the SST bolts.
*
Tighten the 2 SST bolts equally into the 2 rear differential mount cushion holes.
4. TEMPORARILY TIGHTEN DIFFERENTIAL CARRIER ASSEMBLY WITH DIFFERENTIAL SUPPORT
HINT
Refer to the procedure from Temporarily Tighten Differential Carrier Assembly with Differential Support See: Differential
Carrier/Service and Repair/Removal and Replacement/Installation.