RX 350 FWD V6-3.5L (2GR-FE) (2010)
(a) Using SST, remove the diaphragm oil seal from the rear differential carrier assembly.
Text in Illustration
SST : 09308-00010
8. INSTALL DIAPHRAGM OIL SEAL
(a) Using SST and a press, install a new diaphragm oil seal into the rear differential carrier assembly.
Text in Illustration
SST : 09506-35010
SST : 09554-22010
NOTICE:
*
Install the diaphragm oil seal uniformly.
*
Press fit the diaphragm oil seal straight.
Distance (A):
0.7 to 1.3 mm (0.0276 to 0.0512 in.)
(b) Apply a light coat of MP grease to the lip of the new diaphragm oil seal.
9. INSTALL SPACER See: Differential Carrier/Service and Repair/Overhaul/Reassembly
10. INSTALL CONICAL SPRING WASHER See: Differential Carrier/Service and Repair/Overhaul/Reassembly
11. INSTALL ELECTRO MAGNETIC CONTROL COUPLING SUB-ASSEMBLY See: Differential Carrier/Service and
Repair/Overhaul/Reassembly
12. INSTALL CONNECTOR BRACKET
(a) Install a new clamp to the electro magnetic control coupling wire harness with 2 pieces of tape as shown in the illustration.
Text in Illustration