RX 350 FWD V6-3.5L (2GR-FE) (2010)
(b) Using a hexagon wrench (10 mm), remove the rear differential drain plug and gasket to drain the differential oil.
(c) Using a hexagon wrench (10 mm), install the rear differential drain plug with a new gasket.
Torque : 39 Nm (398 kgf-cm, 29 ft-lbf)
(d) Using a hexagon wrench (10 mm), temporarily install the differential inspection plug.
HINT
Add differential oil before installing a new gasket and fully tightening the differential inspection plug.
3. REMOVE REAR DRIVE SHAFT ASSEMBLY
for TMC made: See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Rear Drive Shaft Assembly (For TMC
Made)/Removal
for TMC made: See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Rear Drive Shaft Assembly (For TMMC
Made)/Removal
4. REMOVE REAR DRIVE SHAFT SNAP RING
for TMC made: See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Rear Drive Shaft Assembly (For TMC
Made)/Disassembly
for TMC made: See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Rear Drive Shaft Assembly (For TMMC
Made)/Disassembly
5. REMOVE REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL
(a) Using SST, remove the rear differential side gear shaft oil seal from the differential carrier assembly.
SST : 09308-00010
6. INSTALL REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL
(a) Using SST and a hammer, install a new rear differential side gear shaft oil seal into the differential carrier assembly.