RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-1646003.png)
(g) Pull out the propeller with center bearing shaft assembly from the transfer.
NOTICE:
*
When removing the propeller shaft, do not apply excessive force to the universal joint.
*
During and after the removal of the propeller shaft, keep the universal joint angle straight (within 15 degrees).
*
Be careful not to damage the oil seal.
(h) Insert SST into the transfer to prevent oil leakage.
SST : 09325-20010
NOTICE:
Be careful not to damage the oil seal.
From 08/2009
DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY: REMOVAL
1. PRECAUTION (w/ Air Suspension)
See: Steering and Suspension/Suspension/Service Precautions/Suspension Control System
2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
(a) Depress the brake pedal and hold it.
(b) Using a hexagon wrench (6 mm), loosen the cross groove joint set bolts 1/2 turn.
NOTICE:
*
Put a piece of cloth or equivalent into the inside of the universal joint cover so that the boot does not touch the inside of the
universal joint cover.
*
Do not remove the bolts.
Text in Illustration
(c) Place matchmarks on the rear propeller shaft and rear drive pinion flange sub-assembly.
