RX 350 FWD V6-3.5L (2GR-FE) (2010)
Text in Illustration
(d) Remove the 4 nuts, 4 bolts and 4 washers.
(e) Using a brass bar and a hammer, remove the propeller with center bearing shaft assembly.
(f) Remove the 4 bolts and 4 No. 2 center support bearing washers.
NOTICE:
When removing the bolts and washers, do not apply excessive force to the universal joint.
(g) Pull out the propeller with center bearing shaft assembly from the transfer.
NOTICE:
*
When removing the propeller shaft, do not apply excessive force to the universal joint.
*
During and after the removal of the propeller shaft, keep the universal joint angle straight (within 15 degrees).
*
Be careful not to damage the oil seal.
(h) Insert SST into the transfer to prevent oil leakage.
SST : 09325-20010
NOTICE:
Be careful not to damage the oil seal.
Up to 08/2009
DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY: INSTALLATION
1. TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY