RX 350 FWD V6-3.5L (2GR-FE) (2010)
Distance:
27.1 mm (1.06 in.)
NOTICE:
*
The dust cover should be completely installed.
*
Be careful not to damage the dust cover.
3. INSTALL FRONT DRIVE SHAFT DUST COVER RH (for 2WD RH Side)
(a) Using SST and a press, install a new drive shaft dust cover RH until distance (A) from the tip of the center drive shaft to the drive shaft dust
cover RH meets the specification.
SST : 09527-10011
Distance (A):
110.5 mm (4.35 in.)
NOTICE:
*
The dust cover should be completely installed.
*
Be careful not to damage the dust cover.
4. INSTALL FRONT DRIVE SHAFT DUST COVER LH
(a) Using SST and a press, install a new drive shaft dust cover LH.
SST : 09527-10011
NOTICE:
*
The dust cover should be completely installed.
*
Be careful not to damage the dust cover.
5. INSTALL FRONT AXLE OUTBOARD JOINT BOOT
(a) Wrap the splines of the drive shaft with protective tape to prevent the boot from being damaged.
Text in Illustration
(b) Install new parts to the outboard joint shaft in the following order:
(1) No. 2 front axle outboard joint boot clamp