RX 350 FWD V6-3.5L (2GR-FE) (2010)
(2) Front axle outboard joint boot
(3) Front axle outboard joint boot clamp
(c) Pack the front drive outboard joint shaft and front axle outboard joint boot with grease.
Grease Capacity:
6. INSTALL FRONT AXLE OUTBOARD JOINT BOOT CLAMP
(a) Hold the drive shaft in a vise between aluminum plates.
NOTICE:
Do not overtighten the vise.
(b) Install the front axle outboard joint boot clamp onto the front axle outboard joint boot.
(c) Place SST onto the front axle outboard joint boot clamp.
SST : 09521-24010
(d) Tighten SST so that the front axle outboard joint boot clamp is pinched.
NOTICE:
Do not overtighten SST.
(e) Using SST, measure the clearance of the front axle outboard joint boot clamp.
SST : 09240-00020
Clearance:
0.5 to 1.5 mm (0.0197 to 0.0591 in.)
NOTICE:
If the measured value is greater than the specified value, retighten the clamp.
7. INSTALL NO. 2 FRONT AXLE OUTBOARD JOINT BOOT CLAMP
(a) Install the No. 2 front axle outboard joint boot clamp onto the front axle outboard joint boot.
(b) Place SST onto the No. 2 front axle outboard joint boot clamp.