RX 350 FWD V6-3.5L (2GR-FE) (2010)
SST : 09520-01010
NOTICE:
When removing the rear drive shaft assembly, keep it level.
Disassembly
DRIVE SHAFT / PROPELLER SHAFT: REAR DRIVE SHAFT ASSEMBLY (for TMMC Made): DISASSEMBLY
1. REMOVE REAR DRIVE SHAFT SNAP RING
(a) Using a screwdriver, remove the rear drive shaft snap ring.
2. REMOVE NO. 2 REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP
(a) Using needle-nose pliers, remove the No. 2 rear drive shaft inboard joint boot clamp as shown in the illustration.
3. REMOVE REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP
(a) Using needle-nose pliers, remove the rear drive shaft inboard joint boot clamp as shown in the illustration.
4. SEPARATE REAR DRIVE SHAFT INBOARD JOINT BOOT
(a) Separate the rear drive shaft inboard joint boot from the inboard joint assembly.
5. REMOVE REAR DRIVE SHAFT INBOARD JOINT ASSEMBLY
(a) Remove the grease from the inboard joint assembly.
(b) Put matchmarks on the rear drive shaft inboard joint assembly and rear drive shaft outboard joint shaft assembly.
Text in Illustration