RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-1638002.png)
(b) Check that the inboard joint slides smoothly in the thrust direction.
(c) Check that there is no excessive play in the radial direction of the inboard joint.
(d) Check the boots for damage.
(e) Check whether the drive shaft dimension (A) is within the following specification.
Dimension (A):
750.6 mm (2.46 ft.)
Rear Drive Shaft Assembly (for TMMC Made)
DRIVE SHAFT / PROPELLER SHAFT: REAR DRIVE SHAFT ASSEMBLY (for TMMC Made): INSPECTION
1. INSPECT REAR DRIVE SHAFT ASSEMBLY
(a) Check that there is no excessive play in the radial direction of the outboard joint.
(b) Check that the inboard joint slides smoothly in the thrust direction.
(c) Check that there is no excessive play in the radial direction of the inboard joint.
(d) Check the boots for damage.
(e) Check whether the drive shaft dimension (A) is within the following specification.
Dimension (A):
751.4 mm (2.46 ft.)
