RX 350 FWD V6-3.5L (2GR-FE) (2010)
14. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL See: Body and
Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and Repair/Overhaul/Reassembly
15. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Overhaul/Reassembly
16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
17. INITIALIZE POWER WINDOW CONTROL SYSTEM
See: Testing and Inspection/Programming and Relearning/Initialization
From 08/2009
WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR (for Rear Door): INSTALLATION
NOTICE:
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY
NOTICE:
The regulator arm must be below the intermediate position when installing the rear power window regulator motor assembly.
(a) Using a T25 "TORX" socket wrench, install the rear power window regulator motor assembly with the 3 screws.
Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)
HINT
A new rear window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
2. INSTALL REAR DOOR WINDOW REGULATOR ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Overhaul/Reassembly
3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Overhaul/Reassembly
4. INSTALL REAR DOOR REAR GUIDE SEAL See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Overhaul/Reassembly
5. INSTALL REAR DOOR WINDOW REAR GUIDE SUB-ASSEMBLY See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service
and Repair/Overhaul/Reassembly
6. INSTALL REAR DOOR GLASS RUN See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Overhaul/Reassembly
7. INSTALL REAR DOOR SERVICE HOLE COVER See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Overhaul/Reassembly
8. INSTALL REAR DOOR TRIM BRACKET See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Overhaul/Reassembly
9. INSTALL REAR DOOR FRAME GARNISH See: Body and Frame/Doors, Hood and Trunk/Doors/Rear Door/Service and
Repair/Overhaul/Reassembly