RX 350 FWD V6-3.5L (2GR-FE) (2010)
/Page-3824001.png)
Headlamp Wiper Switch: Service and Repair
Removal
Up to 08/2009
WIPER / WASHER: HEADLIGHT CLEANER SWITCH: REMOVAL
1. PRECAUTION (w/ Air Suspension)
NOTICE:
w/ Navigation System for HDD:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Air Suspension)
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. REMOVE INSTRUMENT PANEL GARNISH LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
4. REMOVE NO. 1 SWITCH HOLE BASE See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
5. REMOVE HEADLIGHT CLEANER SWITCH ASSEMBLY
(a) Disengage the 2 claws and remove the headlight cleaner switch assembly as shown in the illustration.
From 08/2009
WIPER / WASHER: HEADLIGHT CLEANER SWITCH: REMOVAL
1. PRECAUTION (w/ Air Suspension)
NOTICE:
w/ Navigation System for HDD:
After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of
memory and settings. As a result, after turning the engine switch off, make sure to wait at least 60 seconds before disconnecting the
cable from the negative (-) battery terminal.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Air Suspension)
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
3. REMOVE INSTRUMENT PANEL GARNISH LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Removal and Replacement/Removal
4. REMOVE NO. 1 SWITCH HOLE BASE See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
