RX 400h AWD V6-3.3L (3MZ-FE) Hybrid (2007)
a. Disconnect the connector.
b. Remove the screw.
c. Disengage the 2 claws and the pin.
d. Remove the steering pad switch RH.
INSTALLATION
1. INSTALL STEERING PAD SWITCH LH
a. Engage the 2 claws and the pin.
b. Install the steering pad switch LH with the screw.
c. Connect the connector.
2. INSTALL STEERING PAD SWITCH RH
a. Engage the 2 claws and the pin.
b. Install the steering pad switch RH with the screw.
c. Connect the connector.
3. INSTALL STEERING PAD
4. INSTALL NO.3 STEERING WHEEL COVER LOWER
5. INSTALL NO.2 STEERING WHEEL COVER LOWER
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. PERFORM INITIALIZATION
NOTE: Some systems need initialization when disconnecting the cable from the negative battery terminal.
8. INSPECT STEERING PAD
9. INSPECT SRS WARNING LIGHT