RX 400h AWD V6-3.3L (3MZ-FE) Hybrid (2007)
a. Engage the clamp to install the skid control buzzer assembly.
2. INSTALL DISTANCE CONTROL ECU ASSEMBLY WITH SKID CONTROL BUZZER ASSEMBLY
a. Install the distance control ECU assembly with skid control buzzer assembly with the bolt.
NOTE: Do not install the distance control ECU assembly if it has been damaged or impacted in any way.
b. Connect the 2 connectors.
3. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY
4. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER
5. INSTALL FRONT DOOR SCUFF LH PLATE
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. INITIALIZE DISTANCE CONTROL ECU ASSEMBLY
NOTE: After replacing the distance control ECU, it is necessary to initialize the distance control ECU so that the ECU can recognize the
specification of the vehicle.
a. Be sure to perform the following procedures after replacing the distance control ECU.
1. Turn the ignition switch to the on position.
2. Turn the cruise main switch on.
3. With the brake pedal depressed, push the cruise control main switch to RES/ACC 3 times within 3 seconds. Check that the buzzer sounds
at this time.