RX 400h AWD V6-3.3L (3MZ-FE) Hybrid (2007)
3. REMOVE TIRE PRESSURE WARNING RECEIVER ASSEMBLY
(a)
Disconnect the connector.
(b) Remove the bolt and the tire pressure warning receiver assembly.
INSTALLATION
1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY
(a)
Install the tire pressure warning receiver assembly with the bolt.
Torque: 7.5 N*m (77 kgf*cm, 66 in.*lbf)
(b) Connect the connector.
2. INSTALL ROOF HEADLINING ASSEMBLY
HINT:
Refer to the instructions for installation of the roof headlining assembly.
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
4. INSPECT TIRE PRESSURE WARNING SYSTEM
5. PERFORM INITIALIZATION
HINT:
Some systems need initialization after reconnecting the cable to the negative battery terminal.