RX 400h AWD V6-3.3L (3MZ-FE) Hybrid (2007)
g. Align the protruding part with the neutral basic line.
NOTICE: There is play on the nut stopper side (protruding part). Align the center point of the range of the play with the neutral basic line.
h. Tighten the 2 bolts in the order shown in the illustration.
Torque: 13 Nm (133 kgf-cm, 10 ft. lbs.)
i.
Using a screwdriver, stake the nut with the lock plate.
j.
Install the control shaft lever, washer and nut.
Torque: 6.9 Nm (70 kgf-cm, 61 inch lbs.)
2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
a. Move the shift lever to the N position.
b. Install a new clip to the control bracket.