RX 400h AWD V6-3.3L (3MZ-FE) Hybrid (2007)
3. Tie the tires together with 2 wire harnesses.
CAUTION: Make sure that the wire harness is tight. Looseness in the wire harness results in the tires coming free due to the
shock when the airbag is deployed.
f.
Install the SST.
1. Connect the SST connector.
SST 09082-00700
NOTE: To avoid damaging the SST connector and wire harness, do not lock the secondary lock of the twin lock. Also, secure some slack
for the SST wire harness inside the tire.
2. Move the SST at least 10 m (33 ft) away from the airbag tied down to the tires.
g. Deploy the airbag.
1. Connect the red clip of the SST to the battery positive (+) terminal and the black clip of the SST to the negative (-) terminal.
2. Check that no one is within a 10 m (33 ft) radius of the tire which the driver side knee airbag assembly is tied to.
3. Press the SST activation switch and deploy the airbag.
CAUTION: When deploying the airbag, make sure that no one is near the tire.
HINT: The airbag is deployed as the LED of the SST activation switch comes on.