RX 400h FWD V6-3.3L (3MZ-FE) Hybrid (2006)
_hybrid/Page-1043002.png)
2. DISCONNECT SKID CONTROL SENSOR WIRE
a. Disconnect the connector from the skid control sensor.
NOTICE: Be careful not to damage the speed sensor.
3. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY
4. REMOVE REAR DISC
5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
6. REMOVE SKID CONTROL SENSOR
a. Mount the rear axle hub in a vise using aluminum plates.
NOTICE: Replace the hub and bearing assembly if it is dropped or receives a strong shock.
b. Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST
SST 09520-00031 (09521-00010, 09520-00040), 09521-00020
c. Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the hub bearing assembly.
SST 09520-00031 (09521-00010, 09520-00040), 09521-00020, 09950-00020
NOTICE:
^
Keep the sensor away from magnets.
^
Pull the skid control sensor off straight, taking care not to make contact with the skid control sensor rotor.
^
If the speed sensor rotor is damaged or deformed, replace the hub and bearing assembly.
^
Do not scratch the contact surface of axle hub and the skid control sensor.
^
Do not attach foreign matter to the speed sensor rotor and tip.
INSPECTION
1. INSPECT SKID CONTROL SENSOR
a. Inspect the skid control sensor. If any of the following occurs, replace with a new skid control sensor:
^
The surface of the skid control sensor is cracked, dented, or chipped off.
^
The connector is scratched, cracked, or damaged.
^
The skid control sensor has been dropped.
