RX 400h FWD V6-3.3L (3MZ-FE) Hybrid (2006)
_hybrid/Page-481002.png)
b. Remove the 6 bolts and transmission input damper from the flywheel.
3. REMOVE FLYWHEEL SUB-ASSEMBLY
a. Using SST, hold the crankshaft.
SST 09213-54015 (91651-60855), 09330-00021
b. Remove the 8 bolts and flywheel.
4. REMOVE ENGINE REAR OIL SEAL
a. Using a knife, cut off the oil seal lip.
b. Using a screwdriver with the tip taped, pry out the oil seal.
NOTICE: After the removal, check that the crankshaft is not damaged. If it is damaged, smooth the surface with 400-grit sandpaper.
INSTALLATION
