RX 400h FWD V6-3.3L (3MZ-FE) Hybrid (2006)
Drive Motor Control Module: Service and Repair
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE RH
3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
4. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.2
5. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
6. REMOVE HYBRID VEHICLE CONTROL ECU
a. Disconnect the 3 wire harness clamps.
b. Disconnect the 6 connectors from the hybrid vehicle control ECU.
c. Remove the 2 nuts and hybrid vehicle control ECU.
7. REMOVE ECM BRACKET NO.1
a. Remove the 2 screws and ECM bracket No.1.
8. REMOVE ECM BRACKET NO.2
a. Remove the 2 screws and ECM bracket No.2.
9. REMOVE WIRE HARNESS CLAMP BRACKET