RX 400h FWD V6-3.3L (3MZ-FE) Hybrid (2006)
Impact Sensor: Service and Repair
Front Airbag Sensor
REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE HEADLIGHT ASSEMBLY
4. REMOVE FRONT AIRBAG SENSOR LH
a. Remove the 2 bolts and the front airbag sensor LH.
b. Disconnect the connector from the front airbag sensor LH.
INSTALLATION
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. INSTALL FRONT AIRBAG SENSOR LH
a. Check that the ignition switch is off.
b. Check that the battery negative (-) terminal is disconnected.
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
c. Connect the connector to the front airbag sensor LH.
d. Install the front airbag sensor LH with the 2 bolts.
Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)