RX 400h FWD V6-3.3L (3MZ-FE) Hybrid (2006)
Seat Occupant Sensor: Service and Repair
REMOVAL
1. PRECAUTION
CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE FRONT SEAT ASSEMBLY
4. REMOVE OCCUPANT CLASSIFICATION ECU
a. Disconnect the 2 connectors from the occupant classification ECU.
b. Using a screwdriver, remove the occupant classification ECU.
INSTALLATION
1. INSTALL OCCUPANT CLASSIFICATION ECU
a. Check that the ignition switch is off.
b. Check that the negative battery (-) terminal is disconnected.
CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.
c. Connect the 2 connectors to the occupant classification ECU.