RX 400h FWD V6-3.3L (3MZ-FE) Hybrid (2006)
Drive Motor Circuit Breaker Sensor: Service and Repair
Rear Circuit Breaker Sensor
REMOVAL
1. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL
2. REMOVE DECK BOARD SUB-ASSEMBLY
3. REMOVE DECK FLOOR BOX REAR
4. REMOVE REAR FLOOR FINISH PLATE
5. REMOVE DECK FLOOR BOX FRONT
6. REMOVE DECK BOARD SUB-ASSEMBLY NO.2
8. REMOVE DECK SIDE TRIM BOX RH
9. REMOVE DECK SIDE TRIM BOX LH
10. REMOVE REAR CIRCUIT BREAKER SENSOR
a. Remove the rear circuit breaker sensor (LH).
1. Move the outer section to the wire harness side as illustrated, then disconnect the rear circuit breaker sensor (LH).
2. Remove the 2 bolts and rear circuit breaker sensor (LH).
b. Remove the rear circuit breaker sensor (RH).
1. Move the outer section to the wire harness side as illustrated, then disconnect the rear circuit breaker sensor (RH).