RX 400h FWD V6-3.3L (3MZ-FE) Hybrid (2006)
Power Steering Motor
5. INSPECT POWER STEERING LINK ASSEMBLY (POWER STEERING MOTOR)
a. Measure the resistance according to the value(s) in the table.
Resistance
REASSEMBLY
NOTICE: When installing, coat the parts indicated by arrows with silicon grease.
1. INSTALL STEERING RACK END SUB-ASSEMBLY
a. Install 2 new claw washers.
HINT: Align the claws of the claw washer with the steering rack grooves.
b. Using SST, install the steering rack end sub assembly (RH side).
SST 09922-10010
Torque: 74 Nm (755 kgf-cm, 55 ft. lbs.)
NOTICE:
^
Use SST 09922-10010 following the direction shown in the illustration.
^
Use a torque wrench with a fulcrum length of 345 mm (13.58 inch)
HINT: Using SST, hold the steering rack and install the steering rack end sub-assembly