RX 400h FWD V6-3.3L (3MZ-FE) Hybrid (2006)
_hybrid/Page-1251010.png)
b. Temporarily install a new steering rack boot No.2 clamp to the large opening of the steering rack boot No.2 at the position shown by arrow
(A).
NOTICE:
^
Use a new steering rack boot No.2 clamp.
^
Do not expand the steering rack boot No.2 clamp more than necessary for installation.
^
Do not deform the steering rack boot No.2 clamp.
^
Tightening force of the steering rack boot No.1 clamp becomes uneven if it is installed after being expanded as shown in the illustration.
As a result, rust is caused by water entering from the clearance between the boot and rack housing, causing a malfunction.
^
Use only the supply parts which are applicable to the vehicle to secure the boot.
HINT: After disengaging the claw of a new steering rack boot No.2 clamp, temporarily install it from the end without expanding the clamp
diameter more than necessary.
c. Install the rack boot No.2 to the groove on the rack housing.
NOTICE:
^
Be careful not to damage or twist the boot.
^
Do not damage the steering rack boot No.2.
^
Ensure that the steering rack boot No.2 clamp is installed before installing the steering rack boot No.2 to the rack housing.
3. INSTALL STEERING RACK BOOT NO.1
HINT: Perform the same procedure as for the steering rack boot No.2.
4. INSTALL STEERING RACK BOOT NO.2 CLAMP
a. Using pliers and a screwdriver, install the steering rack boot No.2 clamp.
NOTICE:
^
Be careful not to damage the steering rack boot No.2.
^
Do not twist the steering rack boot No.2.
HINT: Make sure that the protrusion of the steering rack boot clamp is positioned within the shown in the illustration.
