RX 400h FWD V6-3.3L (3MZ-FE) Hybrid (2006)
^
Be sure to install the tripod in the correct direction.
f.
Using a snap ring expander, install a new front inner shaft snap ring.
g. Pack the inboard joint shaft and boot with grease.
Grease capacity: 155 to 175 g (5.5 to 6.2 oz.)
h. Align the matchmarks, install the inboard joint assembly to the outboard joint shaft assembly.
13. INSTALL INBOARD JOINT BOOT
a. Install the inboard joint boot to the inboard joint assembly.
14. INSTALL INBOARD JOINT BOOT NO.2 CLAMP
a. Hold the outboard joint shaft assembly between aluminum plates in a vise.
NOTICE: Do not overtighten the vise.
b. Install the inboard joint boot No.2 clamp onto the boot.
c. Place SST onto the inboard joint boot No.2 clamp.
SST09521-24010
d. Tighten the SST so that the inboard joint boot No.2 clamp is pinched.
SST 09521-24010
NOTICE: Do not overtighten the SST.