RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Trunk / Liftgate Motor: Service and Repair
Installation
DOOR / HATCH: POWER BACK DOOR DRIVE UNIT: INSTALLATION
1. INSTALL POWER BACK DOOR UNIT ASSEMBLY
(a) Clean the threaded portion on the vehicle body with a non-residue solvent.
(b) Apply adhesive to the threads of the 7 bolts.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
(c) Engage the claw as shown in the illustration.
(d) Install the power back door unit with the 5 bolts.
Torque : 31 Nm (316 kgf-cm, 23 ft-lbf)
(e) Connect the connector.
(f) Install the 2 bolts.
Torque : 31 Nm (316 kgf-cm, 23 ft-lbf)
2. INSTALL REAR ROOF SIDE RAIL PAD LH
(a) Engage the 2 fasteners and install the rear roof rail pad LH.
3. INSTALL UPPER BACK WINDOW PANEL TRIM See: Service and Repair/Overhaul/Reassembly
4. INSTALL ROOF HEADLINING ASSEMBLY
HINT
Refer to the procedure from Install Roof Headlining Assembly See: Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Installation.
5. INITIALIZE POWER BACK DOOR SYSTEM