RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
(b) Slide the front door lock assembly downward, and remove the front door lock assembly and cables as a unit.
(c) Remove the door lock wiring harness seal from the front door lock assembly.
(d) Remove the front door lock remote control cable assembly.
(e) Using a screwdriver, disengage the 3 claws.
HINT
Tape the screwdriver tip before use.
(f) Remove the front door inside locking cable assembly.
Installation
DOOR LOCK: FRONT DOOR LOCK: INSTALLATION
1. INSTALL FRONT DOOR LOCK ASSEMBLY
NOTICE:
*
When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.
*
Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
*
Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may
result in a malfunction of the front door lock assembly.
(a) Install the front door inside locking cable assembly.
(b) Engage the 3 claws.