RX 450h AWD V6-3.5L (2GR-FXE) Hybrid (2011)
Bolt:
L
35.0 mm (1.38 in.)
M
6.0 mm (0.236 in.)
Pitch
1.0 mm (0.0394 in.)
NOTICE:
*
Tighten the bolts by hand until they become difficult to turn.
*
Do not tighten the bolts excessively.
(2) After connecting the following SST to each other, connect them to the steering pad.
SST : 09082-00802
09082-10801
09082-30801
(3) Wind 3 wires at least 2 times each around each of the bolts installed on the left and right sides of the steering pad.
CAUTION:
*
Tightly wind the wires around the bolts without any slack.
*
Make sure that the wires are tight. If there is slack in the wires, the steering pad may break loose when the airbag is deployed.
(4) Face the airbag deployment side of the steering pad upward on top of an unneeded tire and wheel set. Separately tie the left and right sides
of the steering pad to the wheel through the hub nut holes. Position the SST connector so that it hangs downward through the hub hole of
the wheel.
CAUTION:
*
Make sure that the wires are tight. If there is slack in the wires, the steering pad may break loose when the airbag is deployed.