RX 450h FWD V6-3.5L (2GR-FXE) Hybrid (2010)
4. INSTALL NO. 3 BRAKE ACTUATOR TUBE
NOTICE:
*
Do not damage the No. 3 brake actuator tube or brake actuator and brake booster pump.
*
When installing the No. 3 brake actuator tube, hold the tube and brake actuator and brake booster pump securely.
*
When tightening the nut, make sure that other parts do not move with the nut.
(a) Using a union nut wrench, connect the No. 3 brake actuator tube.
Torque : 15 Nm (155 kgf-cm, 11 ft-lbf)
NOTICE:
Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench See:
Service Precautions.
5. INSTALL CONNECTOR BOX
(a) Install the connector box.
(1) Install the connector box with the nut.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
(2) Attach the wiring harness clamp.
6. INSTALL BRAKE ACTUATOR HOSE
(a) With the paint mark on the hose end facing downward, install the brake actuator hose to the brake actuator with the hose clip.
NOTICE:
When inserting the brake actuator hose, be careful that there is no excessive weight applied to the union of the brake actuator
(especially in the vertical direction).