RX 450h FWD V6-3.5L (2GR-FXE) Hybrid (2010)
(b) Disconnect the F9 power steering ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (POWER STEERING ECU BRANCH WIRE)
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)
(a) Turn the power switch on (IG).
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Text in Illustration
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)
(a) Turn the power switch off.
(b) Disconnect the F10 power steering ECU connector.
(c) Measure the resistance according to the value(s) in the table below.