RX 450h FWD V6-3.5L (2GR-FXE) Hybrid (2010)
without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
NOTICE:
*
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
*
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) See: Service
Precautions.
*
The "with SST" torque value is effective when SST is parallel to the torque wrench.
2. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
HINT
Use the same procedure for bank 1 and bank 2.
SST : 09224-00010
without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
NOTICE:
*
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
*
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) See: Service
Precautions.
*
The "with SST" torque value is effective when SST is parallel to the torque wrench.
3. INSTALL EXHAUST MANIFOLD
(a) Install the exhaust manifold See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service and Repair/Installation.
From 08/2009
2GR-FXE ENGINE CONTROL: AIR FUEL RATIO SENSOR: INSTALLATION
1. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)
(a) Using SST, install the air fuel ratio sensor to the exhaust manifold LH.
Text in Illustration
SST : 09224-00010
without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
NOTICE:
*
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).