RX 450h FWD V6-3.5L (2GR-FXE) Hybrid (2010)
(c) Connect the 2 wire harness clamps and oxygen sensor connector.
5. INSPECT FOR EXHAUST GAS LEAK
6. INSTALL FRONT FLOOR COVER LH See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service and Repair/Installation
From 08/2009
2GR-FXE ENGINE CONTROL: HEATED OXYGEN SENSOR: INSTALLATION
1. INSTALL NO. 2 OXYGEN SENSOR
(a) Using SST, install the No. 2 oxygen sensor to the front exhaust pipe assembly.
Text in Illustration
SST : 09224-00010
without SST - Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)
with SST - Torque : 40 Nm (408 kgf-cm, 30 ft-lbf)
NOTICE:
*
The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
*
The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) See: Service
Precautions.
*
The "with SST" torque value is effective when SST is parallel to the torque wrench.
2. INSTALL FRONT EXHAUST PIPE ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
3. INSTALL NO. 3 FRONT EXHAUST PIPE SUB-ASSEMBLY
(a) Using a plastic hammer and wooden block, tap in a new gasket until its surface is flush with the No. 3 front exhaust pipe sub-assembly.