RX 450h FWD V6-3.5L (2GR-FXE) Hybrid (2010)
7. INSPECT SHIFT LEVER POSITION See: Transmission and Drivetrain/Continuously Variable Transmission/Transaxle/Shift Linkage/Shift
Cable/Adjustments
8. ADJUST SHIFT LEVER POSITION See: Transmission and Drivetrain/Continuously Variable Transmission/Transaxle/Shift Linkage/Shift
Cable/Adjustments
9. INSPECT SHIFT LEVER OPERATION See: Transmission and Drivetrain/Continuously Variable Transmission/Transaxle/Shift Linkage/Shift
Cable/Adjustments
10. INSTALL NO. 1 ENGINE UNDER COVER
From 08/2009
P313 HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER POSITION SENSOR: INSTALLATION
1. INSTALL SHIFT LEVER POSITION SENSOR
(a) Install the shift lever position sensor to the manual valve shaft.
(b) Temporarily install the 2 bolts.
(c) Place a new lock plate and tighten the nut.
Text in Illustration
Torque : 6.9 Nm (70 kgf-cm, 61 in-lbf)
(d) Temporarily install the control shaft lever.
(e) Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
(f) Remove the control shaft lever.
(g) Align the protruding part with the neutral basic line.