RX 450h FWD V6-3.5L (2GR-FXE) Hybrid (2010)
4. REMOVE NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR See: Body and Frame/Bumper/Rear Bumper/Service and
Repair/Removal and Replacement/Removal
5. REMOVE ACTIVE STABILIZER CONTROL ECU ASSEMBLY
(a) Remove the bolt and ground wire from the active stabilizer ECU bracket.
(b) As shown in the illustration, disconnect the 3 clamps and each connector to separate the wire harness from the active stabilizer control ECU
assembly.
Text in Illustration
(c) Remove the 3 nuts, clip and active stabilizer control ECU assembly from the active stabilizer ECU bracket.
Text in Illustration
NOTICE:
*
Avoid any impact to the active stabilizer control ECU assembly.
*
Do not drop the active stabilizer control ECU assembly. If the ECU is dropped, replace it with a new one.
6. REMOVE ACTIVE STABILIZER ECU BRACKET
(a) Remove the 3 bolts and active stabilizer ECU bracket.
Up to 08/2009
SUSPENSION CONTROL: ACTIVE STABILIZER CONTROL ECU: INSTALLATION
1. INSTALL ACTIVE STABILIZER ECU BRACKET
(a) Install the active stabilizer ECU bracket with the 3 bolts.