RX 450h FWD V6-3.5L (2GR-FXE) Hybrid (2010)
Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)
NOTICE:
Temporarily tighten the bolt (A) first, and then fully tighten the 3 bolts in the order of (C), (B) and (A).
2. INSTALL ACTIVE STABILIZER CONTROL ECU ASSEMBLY
(a) Insert the claw of the active stabilizer control ECU assembly into the active stabilizer ECU bracket and temporarily secure the active stabilizer
control ECU assembly with a clip.
Text in Illustration
Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)
(b) Install the active stabilizer control ECU assembly to the active stabilizer ECU bracket with the 3 nuts.
(c) As shown in the illustration, connect the 3 wire harness clamps and each connector.
Text in Illustration
(d) Install the ground wire to the active stabilizer ECU bracket with the bolt.
Torque : 8.4 Nm (86 kgf-cm, 74 in-lbf)
3. INSTALL NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR See: Body and Frame/Bumper/Rear Bumper/Service and
Repair/Removal and Replacement/Installation
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.