RX 450h FWD V6-3.5L (2GR-FXE) Hybrid (2010)
NOTICE:
Do not overtighten the vise.
(2) Install the rear stabilizer link sub-assembly to the rear lower stabilizer bracket as shown in the illustration.
Torque : 90 Nm (918 kgf-cm, 66 ft-lbf)
HINT
If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.
(3) Install the rear stabilizer link sub-assembly to the rear active stabilizer control actuator assembly with the nut (B).
Torque : 90 Nm (918 kgf-cm, 66 ft-lbf)
HINT
If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.
(4) Install the rear stabilizer link sub-assembly with rear lower stabilizer bracket to the rear No. 2 suspension arm assembly LH with the 2 nuts
(A).
Torque : 82 Nm (836 kgf-cm, 60 ft-lbf)
(b) Install the rear stabilizer link sub-assembly (RH Side).
HINT
Perform the same procedure as the LH side.