SC 300 L6-3.0L (2JZ-GE) (1992)
/Page-336004.png)
cap tester:
SST P/N 09230-00030-02 (09231-10080-01) or 09230-00020-02 (09231-10060-01)
6.
When using the radiator cap tester, tilt it more than 30 degrees.
7.
Pump the radiator cap tester several times, and check the maximum pressure.
Pumping speed: 1 pump/second
HINT:
Stop pumping when the valve opens and read the gauge. The gauge must be within the standard values shown when the pressure valve opens.
The cap is considered OK when the pressure holds steady or falls very slowly, but holds within the standard values shown for one minute.
Type: Compact Cap, 88 kPa
1.
Remove coolant and any foreign material on rubber points "A", "B", and "C".
2.
Check that points "A" and "B" are not deformed, cracked, or swollen.
3.
Check that points "B" and "C" are not stuck together.
4.
Apply engine coolant to point "B" before using the radiator cap tester.
^
Radiator Cap Tester:
