SC 300 L6-3.0L (2JZ-GE) (1992)
Distributor: Service and Repair
Ignition Wire Removal
Removal
- Disconnect ignition wires from cap.
- Disconnect distributor electrical connector.
Setting No. 1 TDC
- Remove oil fill cap.
- Looking through fill hole, rotate engine until cam lobe points upward.
Setting No. 1 TDC
- Turn crankshaft counterclockwise approximately 120°.
- Bring crankshaft back clockwise until the crank pulley timing mark aligns with the TDC mark on the cover.
Distributor Hold-down Nut
- Remove hold-down nut and remove distributor from head.
Distributor Alignment