SC 300 L6-3.0L (2JZ-GE) (1992)
/Page-683001.png)
Seals and Gaskets: Service and Repair
Fig. 11 Removing Rear Output Flange
Fig. 12 Removing Rear Oil Seal
1.
Raise and support vehicle, then drain transmission fluid.
2.
Remove front exhaust pipe and heat insulator, then propeller shaft.
3.
Position shift lever in P range, then remove transmission output flange, using wrench 09060-20100 or equivalent, remove output flange attaching
nut and output flange, Fig. 11.
4.
On SC 400 models, remove oil seal from output flange.
5.
On LS 400 models, Remove O-ring from output flange.
6.
On all models, using seal puller 09308-00010 or equivalent, remove extension housing rear oil seal, Fig. 12.
7.
Coat the lip of the new seal with suitable grease, then using seal installer 09309-37010 or equivalent, install seal with lip facing downward. Oil
seal depth from flat end should be .012 inch on SC 400 and .079 inch on LS 400.
8.
On SC 400 models, install oil seal to output flange using special service tool No. 09517-36010 or equivalent.
9.
On LS 400 models, install O-ring to output flange.
10.
On all models, install output flange and two washers. Torque output flange attaching nut to 90 ft. lbs. Stake the nut.
11.
Install front exhaust pipe and propeller shaft, then lower vehicle and check transmission fluid level.
